Description
Designed and produced exclusively for Adventure Ready, the tailgate cutting board take about 5 minutes to install and are incredibly useful. Logo is embedded in driver’s side, two drink holders in the passenger side. Drip groove around cutting area for catching juice, keeping your truck and campsite clean. Just wipe clean with disinfecting wipes before and after each use.
Hardware Included, easy to mount:
- Remove OEM Carpet pad on tailgate.
- Clean surface (optional- put a coat of wax on tailgate interior surface.)
- Clamp Cutting board onto Tailgate (make sure to leave enough room for tailgate to close). We recommend putting the edge of the back edge of the cutting board flush with the back end of the tailgate lip.
- Mark through the cutting board to locate the mounting holes you will need to drill. Ensure your board does not move or slip during this process.
- Unclamp board and double check all marks are visible and lined up according to the holes in the board.
- Using a 1/8″ bit, drill pilot holes int the tailgate. If you find that the 1/8″ hole is too tight, then use a 9/64″ bit. But remember, it is easier to enlarge the hole rather than try to shrink the hole you just drilled.
- Clear away all drill filings and place board on tailgate and visualize the holes in the board line up with the holes you just drilled.
- Screw down board by starting all 8 screws first and then tighten down each screw alternating sides.
Reviews
There are no reviews yet.